Since my fellow DT members at Fire Cracker Designs by Pamela have added my blog to theirs I guess I better start using it. I will start with this little experiment I did of figuring out how to use all my previously unusable Fiskars texture plates with the Cuttlebug.
Start by spritzing both sides of the CS with water.

Next layer from the bottom up Cuttlebug Plate A, Fiskars plate, CS, a folded up paper towel or two depending on the thickeness, a piece of foam, Cuttlebug Plate C.

Run this through the Bug.

Now look at that beautiful design!!! And wasn't that easy! Just wait for it to dry, or speed dry with your heat gun.